
Door won't lift? It may be the spring
Heard a loud bang and now the door won't open? Call anytime for broken spring help in Colorado Springs.
A broken spring is one of the most common garage door failures, and it is rarely subtle. Most people hear a loud bang from the garage, then find the door won't open or the opener strains and lifts it only a few inches. Look above the door. A torsion spring with a clear gap in its coils has snapped.
Springs do the real lifting. A typical two-car steel door weighs well over 100 pounds, and the springs balance that weight so the opener, or your arm, only has to guide it. Once a spring breaks, that balance is gone, which is why the door suddenly feels bolted to the floor.
Every spring is rated for a number of open-and-close cycles. Standard springs are commonly rated around 10,000 cycles, which a busy household can use up in several years when the garage is the main entrance. Rust, a door left out of balance for months and springs undersized for the door's weight all shorten that life. Cold mornings don't help a spring that is already near the end of its life. Wide, heavy two- and three-car doors on newer homes put more load on each spring.
A wound torsion spring holds enough energy to cause serious injury if a winding bar slips or the wrong set screw is loosened. DASMA, the door and opener manufacturers' association, says springs wear out, that both springs should be replaced on a two-spring door even if only one is broken, and that bottom brackets are under extreme tension and should only be adjusted by a trained technician (DASMA safety tips). Don't run the opener with a broken spring, and don't loosen anything on the bottom brackets.
Fixr's garage door repair cost guide (published November 12, 2026) puts a single torsion spring at $150 to $350 and a pair at $200 to $450 nationally. These are national figures, not Colorado Springs quotes. The technician you are connected with sets the price, which depends on the spring size, cycle rating and whether cables or drums were damaged when the spring let go.
On doors with two torsion springs, replacing both at once is the usual advice, since the second spring has the same number of cycles and tends to fail soon after. If your household opens the door many times a day, ask about higher-cycle springs. The extra cost is often small compared with a second service call.

Spring work covers more than swapping the broken coil.
Single or paired springs sized to the door's weight and height.
New springs with safety cables run through them.
Longer-rated springs for doors used many times a day.
Spring tension set so the door holds steady at mid-height.
Cables and drums inspected, since a spring break often damages them.
Ask for springs sized to your door's weight, not whatever is on the truck.
Ask for a price on one spring and on a pair so you can choose.
Ask what the technician's spring and labor warranty covers.

Broken spring in Colorado Springs? Call or send a quick request.
Free — no obligations
Running the opener with a broken spring can strip gears or snap a cable.
Call or send the form and mention the bang or the gap in the spring.
The technician measures the door and spring so the replacement matches the weight.
The door is balanced and the opener's reverse function is checked.

Look at the spring above the door. A gap of an inch or two between coils means it has snapped. Other signs are a loud bang from the garage, a door that lifts only a few inches, or an opener that hums but can't raise the door.
It isn't safe to try. Without the spring, the door is very heavy and can drop suddenly. If a car is trapped inside, say so when you call so the technician knows.
Fixr's November 2026 national guide puts one torsion spring at $150 to $350 and a pair at $200 to $450. Those are national guides, not local quotes. The technician sets the price after seeing your door.
Usually, yes. DASMA advises replacing both springs on a two-spring door even if only one has broken, since they wear at the same rate. The technician can price both options.